We'll be exhibiting! MRO Middle East & AIME - Dubai World Trade Centre, 2-3 February 2027 - Booth 1845

+44 (0) 2476 645 551

[email protected]

3 October 2026 / Technical Guides

BS L164 vs L165 vs L166 vs L167: What’s the Difference?

If you maintain British or European aircraft, you will regularly see BS L164, L165, L166 and L167 called up on drawings and job cards. All four are British Standard aerospace specifications for the same material – 2014A aluminium alloy, clad on both sides with pure aluminium – but they are not interchangeable. This guide explains the differences.

The material: 2014A clad

2014A is a high-strength aluminium-copper alloy (3.9–5.0% copper). Copper gives it strength but reduces its natural corrosion resistance, so for sheet it is supplied clad: a thin layer of pure aluminium is roll-bonded to each face. The cladding protects the core from corrosion with almost no weight penalty, which is why clad 2014A has long been used for fuselage skins, panels and structural repairs.

The four specifications at a glance

Specification Temper Rolling tolerance Replaces (obsolete)
BS L164 T4 (naturally aged) Standard L151
BS L165 T6 (artificially aged) Standard L47, 3L73, L152
BS L166 T4 (naturally aged) Close tolerance 2L89, L108
BS L167 T6 (artificially aged) Close tolerance 2L90

T4 or T6?

The first difference is temper. L164 and L166 are T4: solution heat treated and naturally aged. T4 sheet is more ductile, so it is the better choice where parts are formed, joggled or stretched. L165 and L167 are T6: solution heat treated and artificially aged for higher strength. Typical minimum properties for 1.6–6.0 mm sheet are around 390 MPa tensile strength and 245 MPa proof stress in T4, rising to around 420 MPa tensile and 355 MPa proof stress in T6, with lower elongation.

Standard or close tolerance?

The second difference is thickness tolerance. L166 and L167 are produced to tighter rolling tolerances than L164 and L165. They meet the same chemistry and mechanical requirements, so L166 will always satisfy L164 and L167 will always satisfy L165, but not the other way round. If your drawing calls up a close-tolerance grade, the standard grade cannot be substituted.

Old drawings and obsolete specifications

Older aircraft documentation often quotes obsolete specifications such as L151, L152, L108 or 2L90. The current L164–L167 specifications replace these, as shown in the table above. Always check the approved substitution for your aircraft type before ordering.

Metric gauges

The BS L-series is supplied in metric thicknesses rather than the imperial gauges used for AMS and QQ-A sheet. Typical gauges include 0.50, 0.81, 1.00, 1.20, 1.60 and 2.03 mm.

Where to buy BS L164–L167 in the UK

The L-series can be hard to source. Aerocom Metals stocks all four specifications in thicknesses from 0.45 mm to 2.79 mm – see our 2014A clad sheet page for the full size table, or browse our complete range of aerospace sheet for MRO.

World class metallics from world class manufacturers for world class customers